Multiple smaller co...
 
Notifications
Clear all

Multiple smaller controllers or single large controller?

23 Posts
16 Users
0 Reactions
13.2 K Views
Posts: 59
Topic starter
(@arange98)
Trusted Member
Joined: 12 years ago
[#50077]

I'm looking to expand pixels next year after the success of my small pixel tree this year.

Will likely add 1200 C9 pixels for roof outline and another 1200 nodes for other elements.

Currently using a single sandevices e6804 for the 650 node pixel tree and find it intuitive and working well. I'm using all 4 channels for the tree and so I haven't had to do any injection running the tree at 25% (which is plenty bright).

  1. Since my new plan calls for pixels across the entire house should I get a single 12 channel controller and run cable from it to the various locations (using null pixels, etc. as needed)?
  2. Or is the general practice to buy a few 4 channel units and place them closer to the area being serviced?

Thanks!
Allen


22 Replies
Posts: 431
(@dkelly0802)
Honorable Member
Joined: 11 years ago

It’s a personal choice but I would tend to go with multiple controllers. That way if something goes down you don’t lose your whole show.


Reply
Posts: 486
(@uncledan)
Honorable Member
Joined: 11 years ago

I prefer several controllers myself (small or large) with as few pixels per output as possible. I had some issues last year with some outputs with 800-1000 pixels per output. Lots of darkness when node one dies. I really like the Falcon F4v3 myself. You can add a diff expansion and two receivers to basically have (3) 4 port boards. Lots of options out there


Reply
Posts: 602
Guest
(@bwinter)
Honorable Member
Joined: 10 years ago

I’m a big fan of using multiple small controllers (2-outputs each). You can get your controller closer to the elements (and not worry about long data runs). As long as you’re wireless

And it’s easy to have a backup in case one goes down.


Reply
Posts: 376
(@k-state-fan)
Reputable Member
Joined: 16 years ago

I think it depends on what your layout is. I have a mix larger controller at tree and a couple F4V3 controllers.


Reply
Page 1 / 5
Share: