I am looking at putting some C9 pixels on my house next year. I have heard of the many failures of the Technicolor Pixels and the PixaBulbs and want to buy something high quality. I know the Minleon Pixels use a TLS3005 chip. Does anyone have a wire diagram of these strands? I want to use it with a Sandevices E682 to control them. Thanks.
Scott
High price doesn't mean high quality! I've had quite a few Pixabulbs pointing straight up on my roof for a few months now. I've seen no issues at this point.
I have 200 pixabulbs on my house trim this year and am very happy with them. They are really bright, I have them output filtered on Vixen 3 to 50 percent to not overpower the incandescent bulbs on my display.
There's a whole bunch of Technicolor horror stories out there, but I think the pixabulbs are pretty good. I've got around 250 with zero failures.
I've never heard anything bad about Minleon products. The E682 I believe supports the TLS3005 and it has many more colors for smoother fades
I put up 1100 Pixabulbs on my eaves and roofline this year. About half of them are pointing straight up. No a single hiccup or failure so far.
I have 400 pixabulbs on my house. I had 2 early life failures where the red element failed. There have been
no failures due to water intrusion. I would rate them very High on the reliability scale. that's 99.5% reliability.
Not too shabby. I will be buying more of them.
Tim
I am glad to hear the PixaBulbs are doing good this year. I will order some, but would like 12'' spacing. I only see 6'' spacing listed. Anyone know how I can get the 12'' spacing?
at the pre-sales you can order custom spacing. I have both 10 inch and 12 inch spacing. Now, in reality, that is the length between the pixels, so center to center they are actually 10 1/2 inches and 12 1/2 inches.
Tim
I'm one of those battling Technicolor failure for the second year in a row... this tls3005 chip, does it work with j1sys p12s, advatek pixlite16 or 4 and sandevices e6804? Those are the controllers I have currently...
Louie
