I bought a 17x10 matrix sign from DIYLEDEXPRESS.com. Has anyone had any problems with power through the whole string (one injection) and data? Or will I need to interject power at 2 different places?
Thanks
Robert
Are your pixels 5 or 12 volt? Mine are 5 volt and injected power at every string.
Rick Todd wrote:Are your pixels 5 or 12 volt? Mine are 5 volt and injected power at every string.
Oh my!
No they are 12v. Really hope I will not have to do that with mine.
170 pixels you should not have to inject. At 12v. What controller are you running. If anything I would connect power to both ends fused and let it circle. That way you never go over 75 pixels with out power. My sign I'm building is using 5v. 750 pixels and I'm not injecting at all. The controller I'm hoping to try is only using 2 output also.
See video.....
wbottomley wrote:See video...../div>
That is a HOOT 😉
Well done
rtrip9 wrote:170 pixels you should not have to inject. At 12v. What controller are you running. If anything I would connect power to both ends fused and let it circle. That way you never go over 75 pixels with out power. My sign I'm building is using 5v. 750 pixels and I'm not injecting at all. The controller I'm hoping to try is only using 2 output also.
Fused at both ends and let it circle? Mmmmm. Haven't thought about that. I am just using the cheap DMX-SPI controller I think I got from DIY LED Express.
The controller doesn't matter when it comes to power. You could run a positive fused and a negative from the power supply and only the Dara from the controller and it will still work. And the lights pull power in both directions so direction only matters with data
How big is this sign? Not sure if your using the DIYLEDExpress board or not..
