I picked this up today. It will be a great deal if they are usable.
Yes, they are made by gemmy. Yes, I know that generally speaking gemmy is not something to pursue.
However, I'm hoping they have just repackaged someone elses LED strip pixels. These are extremely well made.
This is a section of LED strip lighting. Each section has 18 leds. Each section has a 'chip' that must control that section.
The strips have the typical cut points with solder pad. There are 4 'wire's at the cut points, they are labeled: +5V, Din, Dout, GND.
Sounds like a pixel strip to me.
I guess the question is: Is this protocol known and supported by any of our DIYC controllers like an E680
Click on the picture for a bigger image:
Got some cheap as well. Haven't played with them, and probably won't for several months. Please post if you have any luck!

