Lightshow Flextech ...
 
Notifications
Clear all

Lightshow Flextech Strip Stuck On

3 Posts
2 Users
0 Reactions
1,537 Views
Posts: 326
Topic starter
(@robertb)
Reputable Member
Joined: 17 years ago
[#34023]

I have a white 108 LED Lightshow Flextech Strips for my arches. One arch last night decided to stay on, all LEDs. This was after I put an extension wire on it. Needed a longer reach from the e682 controller. No matter now if I go back to the original wire or change ports...it stays on. Ironically enough when I swapped out another strip...it did the same thing. It wasn't until this morning I hooked it back to the original port did it come back to life. Keep in mind...the 2nd strip wouldn't change for anything last night.

So I have one that is ALL on. Another was revived after hooking it back up to it's original port.

Any ideas?


2 Replies
Posts: 91
(@rednelb)
Estimable Member
Joined: 13 years ago

Sounds like a cable issue. What are you using?


Reply
Posts: 326
Topic starter
(@robertb)
Reputable Member
Joined: 17 years ago

Unfortunately it's not a cabling issue. Using Cat5. Tried putting it on the shorter cable...and still no joy. Like I said, it was almost like one reset itself.


Reply
Share: