Notifications
Clear all

Sequence lags

3 Posts
2 Users
0 Reactions
1,710 Views
Posts: 512
Topic starter
(@habbosrus)
Honorable Member
Joined: 14 years ago
[#34036]

I have an e6804 running a 20 row x 75 pixel matrix. In testing things looked good with one sequence played at a time. Last night I ran my show for testing and noticed the matrix would lag on moving items after a few songs. The first couple of sequences showed very slight lag which I accept. I then tried changing the order of sequences to see if it was a particular sequence. Still had same issues. I did change the ethernet cable I was using and this seemed to work but after a while the lag was evident, although not as bad as earlier. My question is, is there something that causes signals to accumulate and cause more lag? I'm just guessing at the moment and looking for possibilities. All my other elements worked flawlessly (very bright - still wearing sunny's).
The refresh rate is very low as I'm pushing 375 pixels out of each output on the matrix controller.
Using ws2812b strip.

The sequences were played from laptop running HLS. I then tried running sequences from pi and noticed more lag. Any suggestions? Am I pushing e6804 too hard? Is it something else?


2 Replies
Posts: 295
(@daytimer)
Reputable Member
Joined: 15 years ago

What do you have for a computer? I'm not familiar with HLS, but run the Windows resource monitor and see what your processor usage is. I had an older computer that had worked fine in the past, but with running many more pixels this year, I was noticing 95% processor usage at times. I picked up a quad core refurb with more memory and it is much more smooth.


Reply
Posts: 512
Topic starter
(@habbosrus)
Honorable Member
Joined: 14 years ago

I have a core I5 laptop but it is the same with Raspberry PI (or maybe even slightly worse)


Reply
Share: