At what point are the green and red LEDs supposed to light up on E682?
There are 5 LEDs on the E682, located in a line along the left edge. The
red STATUS LED will be on during normal
operation. The green STATUS LED generally indicates the presence of received SACN/E1.31 data packets, or
that a test pattern is enabled, and will usually light
during normal operation, or flicker rapidly in when a test
pattern is enabled.
The 3
yellow POWER LEDs
indicate the presence or absence
of different power voltages on the
E682 and are used for troubleshooting. The 2 bottom yellow LEDs
indicate the presence of power on the two pixel power
connectors. If either of these LEDs is not lit, it indicates
that no pixel power is being supplied to the corresponding pixel
power input. The upper yellow LED indicate the presence 3.3
volt power, this is the power source that operates the
E682’s electronics. If this LED is not lit the controller is not
receiving power,
Ok. I have 3 e682s and only the 3 yellow lights illuminate on all 3 controllers. What common problem could they all have?
