Kulp k8-pb audio
 
Notifications
Clear all

Kulp k8-pb audio

10 Posts
4 Users
0 Reactions
2,636 Views
Daemon
Posts: 431
Topic starter
(@daemon)
Honorable Member
Joined: 18 years ago
[#55812]

Hi all

I bought a Soundblaster 3 and usb hub to use with my kulp k8 as it doesn't have audio output as this was mentioned in the manual.

I plugged both the USB sound card and my wifi dongle into the hub and can confirm that the wifi is still working well.

Before moving on to testing an fm transmitter I bought I thought I would just try connecting a bose speaker I have with the 3.5mm connector from the Soundblaster, so I put it into aux audio mode, connected them up and started a sequence playing, expecting to hear audio but got nothing.

Are there any settings or anything I would need to enable first or something I am doing wrong?

Thanks


9 Replies
Posts: 226
(@thomasled)
Estimable Member
Joined: 5 years ago

Typically an audio amplifier is needed to directly drive a speaker from a USB sound card.

- Thomas


Reply
Posts: 242
(@rsegreto)
Reputable Member
Joined: 6 years ago

I'm assuming this speaker was alreay powered no? I used a set of headphones to test the audio out of my k8-PB last year and it worked fine.

But also, there is a setting in the FPP that needs to be updated to tell the board to send audio out though the SB3. This should be on the Audio / Video tab if using FPP 5.0, see attached screenshot.

Capture

Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

As was said, the amount of output needed to drive Bose (or any other large speaker) is far more than the miniscule power coming from a SBP3 can provide. Amplifying the signal is a requirement, whether the amplifier is a separate external device or built into the speaker (i.e., "powered speakers").


Reply
Daemon
Posts: 431
Topic starter
(@daemon)
Honorable Member
Joined: 18 years ago

A sound blaster is a USB dac and Amp I thought?


Reply
Page 1 / 2
Share: