I've got a Kulp K8-PB & I'm trying to tie in a SRx1 v4.00. I'm on the struggle bus though. So I've tested the smart receiver & the lights work off there but I'm just trying to get it all setup in FPP & that's where I'm lost.
I've found some guides on setting up smart receivers but I can't really find a mention of these specific receivers... notably, the ID selection & I'm not sure how imperative that is or if it relates to anything in FPP. I'm trying to just run testing via FPP right now so I can know that it's all working but they don't seem to be communicating; no lights, and no data LEDs lighting up on the SR.
In my current config for transparency, ID Selection is somewhat arbitrarily set to B which should be in the auto detect range based off the back of the circuit board. In FPP, I've selected Smart v2 & 1 smart receiver. I've got it hooked up to the K8-BP w/ a brand new Ethernet cable & I've tried a couple already for that matter. I also have all the dip switches in the up (ON) position. As per what I've found, I think that is the way to set it up for an end of chain SR.
I'm kind of at a loss here so I genuinely appreciate any help. Trying to get some lights going this weekend if possible.
Cheers,
Josh
