Help picking out Pi...
 
Notifications
Clear all

Help picking out Pixel types

14 Posts
8 Users
0 Reactions
4,018 Views
Posts: 16
Topic starter
(@bz-mikeh)
Eminent Member
Joined: 11 years ago
Barnabybear wrote:Hi, yes.
Will the tree be flat (ray) or rounded (normal tree style)?
Will it be viewed from one distant postion or from many close postions?
180, 270 or 360 deg?
Do you intend to use it to display video?
Sorry for the questions - and this is just the start to answer your question.

I'm thinking flat style would be best? The viewing distance to the road isn't far 100ft or less. I have purchased a few sequences already that have characters programmed into it (the grinch, frosty snowman) but don't plan on doing any type of videos other then that.


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

Ok. With a flat ray you'll have the tops the same hight and you'll have to decide spacing. The bottom will be arcing. Longest in the middle and gets shorter as you move out. So your bottom support bar or angle will be at the bottom of the outside strings and the others run past it. So you'll need to plan accordingly.


Reply
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago
Utimgr wrote:I'm surprised that nobody is making a node using the PL9823 LED. Its a thru hole 5mm RGB, using the WS2811/2812 protocol. Put this on a board, add a Fresnel lens, dip them in epoxy coating and you have waterproof node.

There is, of course, nothing wrong with that. However most of us simply don't have the time to buy them and the wire needed and to spend time soldering 6 solder joints for each one, then epoxy pot them when we can get a strand of 50 already wired, potted and done for $16.


Reply
Posts: 451
(@utimgr)
Honorable Member
Joined: 14 years ago

wait...wait...it IS DIY right? ha! Well the reason I ask is it seems the currently available square pixels are using 2811 or older technology. Where do you get them for $16, I have been playing with strips only so now its time to experiment with the squares. I did order some of the LED's just to see how they look, and I might consider building my own if they do look better. Part of it is trying to mount them such they are rather invisible until they are turned on.


Reply
Page 2 / 2
Share: