Have a eftover GECE...
 
Notifications
Clear all

Have a eftover GECE 50 pixel controller?

26 Posts
10 Users
0 Reactions
12.2 K Views
pmcpa
Posts: 1390
(@pmcpa)
Noble Member
Joined: 17 years ago
Materdaddy wrote:I don't think that's true. A couple of the default patterns operate on strings at half intervals I thought, which would be different for each size. Maybe they're on 5s or 10s instead of halves? It will be interesting to find out from Jeff when he hooks up the controllers from 25-pixel strings to see if the second 25 don't work quite as expected.

I forgot about that, you, you could be right


Reply
Posts: 2171
(@mschell)
Noble Member
Joined: 18 years ago

I have some 36 count strings and won't be needing the controllers from them. Let me know if you want them...


Reply
Jeff Millard
Posts: 1450
Topic starter
(@jeff-millard)
Noble Member
Joined: 19 years ago

Thank you everyone. I was able to get 41 pixels connected and it would seem the 25 channel controller is the same as a 50. There are some patterns that run the entire length of the 50 pixels, that when used with 25 just have a delay before the next chase. Some of the other patterns work in 3s but there's an occasional set of 2. As long as I was able to get the signal across several sets of 8 I am very happy. Chuck P is sending me two of the controllers so I'm hooked up now. I thank everyone for the help and suggestions. I say I want to get these put away, but I know as soon as I order and build the E681 I'll be dragging them back out again. (I just wish I hadn't missed the 10 sets stashed behind some stuff as the price dropped to 75% off..., some guy walked up with a cart, dug them out right in front of me. I wanted to scream out loud for not looking harder)

Jeff


Reply
Jeff Millard
Posts: 1450
Topic starter
(@jeff-millard)
Noble Member
Joined: 19 years ago

I just uploaded a video of it chasing. Looking at it closer it appears to mirror 1 - 25 and 26 - 50, but I only need it to test.

Jeff


Reply
Materdaddy
Posts: 2368
(@materdaddy)
Famed Member
Joined: 16 years ago

The interesting bit is a controller hard coded for 25 is the bulb enumeration and sequence being run. If the bulbs are enumerated (1-25) and then a chase pattern that starts with 1 and goes sequentially to 25, bulbs 26-50 will get the addresses of 1-25 again and will simply mirror the first half. Interestingly enough, if the first 25 are enumerated, then a RANDOM pattern goes, bulbs 26-50 could get any random addresses and won't mirror 1-25, but will be in a random address numbering order.

If I were you, I'd try a few different patterns with a power-down (unplug) in between since the bulbs keep their address with power.


Reply
Page 2 / 6
Share: