Many years ago back in the incan days I put cup hooks in the fascia boards that are right behind my gutters. I since switched to LEDs and for the last 4 yrs have used RGB nodes. The hooks are still in place and still work great. I have a ranch house with 4 separate sections of gutters and I can put up 3 of the section by standing on my tiptoes since they are above garage entrance, front sidewalk and front porch. The 4th section is where my lot slopes downhill but I use a painters pole with a homemade hook an the end. Works great.
These are all awesome suggestions. I have cup hooks up already. I have made gutter hooks out of brick ties. I may still use those but sure like those listed. Any pictures or videos Jim???
bcowan wrote:I screwed small zip tie anchors every 3 feet and zip tie the EMT to them. This was the first year for the pixels. When I take them down I am going to cut the wires at every 10 foot section of EMT and put weather proof connections. This way I can leave the PixaTrim, EMT and Pixabulbs all together in 10 foot sections. This will make it easy to store and to put up next year.
I use the same zip ties mounts under the eaves and have done exactly as you plan to do with segmented sections joined by connectors for the wiring - it has been working great for three seasons now.
Shane
RobertB wrote:These are all awesome suggestions. I have cup hooks up already. I have made gutter hooks out of brick ties. I may still use those but sure like those listed. Any pictures or videos Jim???
Of the cup hooks or the lights???
Here is a short video I did to test my cell phone video capability. There is no sound. Note the nodes are just hanging pointed down to the ground and they are still very bright.
https://www.youtube.com/watch?v=9xFeKjVxwmA

