Fusing 5 volt Pixel...
 
Notifications
Clear all

Fusing 5 volt Pixel Strings

8 Posts
6 Users
0 Reactions
2,597 Views
Posts: 39
Topic starter
(@gomer23)
Trusted Member
Joined: 9 years ago

Thanks for the replies everyone. Sorry i didn't want it to seem like I wasn't going to use a fuse for each injection point ha. I for some reason thought the fuses were fussing about voltage as well.

thanks for the links for those boards. I will probably look into those for my setup next year for sure. I have some inline holders and from installing car stereos in the past, just need to get some lower amp fuses for this project.


Reply
Posts: 299
(@dcamron)
Reputable Member
Joined: 10 years ago

Fuses protect the upstream device. A short on a pixel or prop should burn out the closest fuse and protect the rest of your display. Without fusing you can blow everything between the prop and the breaker. You can easily lose a controller if you fuse it over the rated amps. The rating per output as well as the overall input rating should be observed. Good PSU's will have over voltage and over current protection although I've seen some cheap PSU's that don't implement that very well. Calculate your load and fuse according to the # of amps you need. Use the correct wire gauge for your load also.


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

To further explain your initial question. The voltage rating on a fuse refers to the upper limit of the insulator material. You can use any voltage up to the listed voltage and it'll work just fine. If you use a higher voltage, you may feel it in your fingers thru the outer insulation, or even worse things like sparks and fire. Most little fuses you might use for something like this are rated to 250V, which is just fine for the application.


Reply
Page 2 / 2
Share: