Flickering pixels b...
 
Notifications
Clear all

Flickering pixels between segments

43 Posts
14 Users
0 Reactions
12.8 K Views
Posts: 79
Topic starter
(@dpdigital)
Trusted Member
Joined: 12 years ago

I am working on getting a diagram put together and posted.

uzelessknowledge wrote:Hey dpdigital. Sounds just like mine. The data was getting corrupted by the extra wire that data was traveling on. I needed up pulling the 3rd pin from the tee that this data was going up. This then caused the data to go straight through and not up that wire.

The more I try to narrow it down, it seems like exactly what you are saying, corrupt data somewhere along the line. That seems like a tedious process to locate where. Can you elaborate with some more detail on what you are saying? "Up pulling the 3rd pin from the tee"?


Reply
Posts: 79
Topic starter
(@dpdigital)
Trusted Member
Joined: 12 years ago

Good news update! (Fingers crossed)

After having re-worked my whole power scheme, I was pondering the whole corrupt data issue so I went back through all the posts to review, because I remembered RobG saying something about resistors. I read it more carefully this time and went out and installed a 100 ohm resistor (between the controller and first pixel) and Bang! Works Awesome! No more flicker.

RobG, I think you were on to the problem early on, but it just took me a bit longer and perhaps a few steps back to catch up and see the suggestion. Thanks again.

I'm still keeping my fingers crossed, but it seems like it is good now.


Reply
Posts: 234
(@uzelessknowledge)
Reputable Member
Joined: 12 years ago

How does the resistor help? What does that do?

Travis
Sent from my iPhone using Tapatalk


Reply
RobG
Posts: 1255
 RobG
(@robg)
Noble Member
Joined: 14 years ago

In short, resistors reduce ringing due to reflection caused by mismatched impedance.
Things get worse when you split your data wire. Reflected signal will travel back to source as well as to any wire at the split point.
The best thing to do is to have small value (33-220) resistor on the output and at the split point (signal in, split, resistor to out 1, resistor to out 2)


Reply
Posts: 150
(@jwamsley07)
Estimable Member
Joined: 12 years ago

I have a very similar issue. I decided to do a pixel grid, so I ordered 500 12v WS2811 pixels. I just got them and hooked them up to my test connection. Each one of the 10 strings I got has at least two pixels that flicker when all white. When it isn't white, it doesn't flicker. The flickering isn't in the same spot on the strings and one of the strings has five of them that flicker when white. I do not have this problem when I use my current 12v pixels, just with these new ones I got in. I have found if I drop the voltage down from 12v to 7-8v on the buck converter the flickering goes away, but of course the white isn't very white.

I find it strange that my current 12V ws2811's don't have the problem, but these new ones I got in do. Any advice or ideas to try?


Reply
Page 6 / 9
Share: