Last seen: Nov 19, 2026
We tried 2400 of them in our mega tree last year (24 strings of 100). My wife didn't like the look of them compared to normal pixels. The light wasn...
I have pixels that are 9 years old that are still going in my display with no problems. I just trashed almost 500 pixels in a small matrix that was o...
When I first noticed the issue, I let him know and he was willing to replace it. But if I could make it work with a simple cable, I was OK with it. ...
Yes, two of my six kulp boards, the usb on the board doesn't work properly. I was able to get one of them to work"ish" by adjusting the pins inside th...
We created our own "Sparkleballs" using 50 clear solo cups and pixels. Works out quite well for our needs. We don't post much to the internet, but ...
Just downloaded it and tried it. Many thanks! Works great!
I downloaded the latest dev build. It did include everything that was in Other to matrix, however the matrix in Vixen is, not sure how to describe it...
I ran both a virtual matrix and mp4 files on my projector without any problems last year. I haven't test FPP 5.xx yet but assume it will still work. ...
34 hours for medium sized tree topper. I use this for the trees that are 10' or smaller using 1"EMT. 100% infill. I've printed four so far. Had my...
I 3D printed two of these stars. One of for over my Nativity and one for the 10' megatree I have. They have been used for two seasons now. About 2...
Running into the same issue on one of my Halloween sequences. I exported using the pre 2.6 setting (Falcon Player Sequence instead of Falcon Player ...
Thanks for the reply. I opened up one of the blowers and applied lubricant to it. It still would not spin up with help. After researching on the in...
