Flickering pixels b...
 
Notifications
Clear all

Flickering pixels between segments

43 Posts
14 Users
0 Reactions
12.8 K Views
Posts: 79
Topic starter
(@dpdigital)
Trusted Member
Joined: 12 years ago

They are only flickering when data is present, more specifically a white signal. When no data is present, they all go dark, but I have experienced some conditions when the string was powered and the vixen software was not running and one of the pixels in question was on red while the rest of the string was dark.

What would be a typical value for the series resistors?


Reply
RobG
Posts: 1255
 RobG
(@robg)
Noble Member
Joined: 14 years ago

WS suggests 33-220 ohms. I had had good luck with 220 ( one at controllers output, and then one at string's input.


Reply
Posts: 79
Topic starter
(@dpdigital)
Trusted Member
Joined: 12 years ago

Ok, tried a few resistor values. 100 ohms still had flicker. 220 ohms caused erratic behavior all the way down the rest of the chain. I think the issue might be noisy power though. I did notice in the process of testing resistors some interesting results. While the signal was transmitting all white to the whole chain, and the flickering was present, I separated the data line to install the resistor and the rest of the chain stayed white (with no new updates coming down the line) but the first pixel was still flickering with the data line disconnected.

I'm thinking that if I put my scope on the +12v line I might be able to see if it is noisy. Thoughts?

I also tried adding pixels to the end of the first power supply while keeping the others connected, kind of like running additional pixels in parallel to the second set, but on the first power supply. The flickering of the pixel on the first power supply stopped, but the first pixel on the second power supply continued flickering.


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

so might be you kinda narrowed it down too a bad power supply maybe


Reply
RobG
Posts: 1255
 RobG
(@robg)
Noble Member
Joined: 14 years ago

PS might be a problem. I recently got a cheap 24V one and it's practically unusable with my floods.


Reply
Page 3 / 9
Share: