davdue wrote:After looking at this I am going to shorten up the driveway strings to just 2 strings of 50 pixels. That way I won't have to do power injection on those runs. I have some more questions before I can order my stuff from them.1. With DIYLEDExpress pixels each string comes with connectors on each end but I will need a connector at the beginning of each run right?
2. Would that be a male or a female connector? Or should I just get a 10' long matching set?
3. So for this layout I would need 13 of them right?
4. What do I need for power injection for the 8 yard runs?
5. I can just inject at the end rather in the middle so can I just use the other half of the 10' connector for that?
With the DIYLEDExpress pixel strings ( and really everyone that has connectors attached ) the input end of the string has a Male connector, and the output end has the Female connector, just like the electrical wiring in your home. This configuration is safer as It is much harder to short across the V+ & V-. All DIYLEDExpress pixels strings also come with a Female connector with approx 12" wire for connecting to your controller. It is always wise to purchase a few extra male and female pigtails and extentions though just in case.
In the yard layout I would inject at the end, not in the middle. Just my opinion, someone else may disagree, with any major ramp/pop or white, the end of the 4th strand may be either dim or pink
Or run at ~75% intensity and you would not need to power inject (PI) at all on the 142 yard runs.
But if you are, don't supply power from the controller, data & gnd only and PI in the middle, both directions.

