I am trying to finish the plan for my first pixels. My show currently only has incandescent lights and some dumb RGB. I have talked about this in another thread but I wanted to show some layouts I drew up in excel to see what you experienced guys think about my power supply and power injection plan. This will all be 18 awg 12V 12mm pixels from DIYLEDExpress. I need to figure this out so I can make the pre-sale by Sunday. Here are my layouts.
Dave,
For the yard, layout tie the V- together for PS 4&5 and 6&7. Feed the first 100 on each run from PS 4 or 6 and feed the last 42 on each run form PS 5 & 7 from the end rather than the middle. You would keep the Data and V- connected at what you have listed as PI point, but NOT the V+. Other than that it looks good to me.
TomL8345 wrote:Dave,For the yard, layout tie the V- together for PS 4&5 and 6&7. Feed the first 100 on each run from PS 4 or 6 and feed the last 42 on each run form PS 5 & 7 from the end rather than the middle. You would keep the Data and V- connected at what you have listed as PI point, but NOT the V+. Other than that it looks good to me.
Ok. Do I have the right number and size of power supplies, or too many. I would like to keep the cost down as much as possible.
Sent from my iPhone using Tapatalk
After looking at this I am going to shorten up the driveway strings to just 2 strings of 50 pixels. That way I won't have to do power injection on those runs. I have some more questions before I can order my stuff from them.
1. With DIYLEDExpress pixels each string comes with connectors on each end but I will need a connector at the beginning of each run right?
2. Would that be a male or a female connector? Or should I just get a 10' long matching set?
3. So for this layout I would need 13 of them right?
4. What do I need for power injection for the 8 yard runs?
5. I can just inject at the end rather in the middle so can I just use the other half of the 10' connector for that?
MikeKrebs wrote:You have a very good number of PSUs "by the book". You should have very adequate power, they will be safe, your lights will be bright!Depending on your actual layout, I would try to use the same psu for each string instead of using a second psu to inject. Since you don't have more than 200 pixels (are these 8/12mm or some other?) in a string, you could inject at the end which would be "simplier".
Yes they are all 8/12mm bullets. I was wondering about using the same power supply. The yard ones will go out towards the street and loop loop back with the power suppliy at the beginning so it would be easy to inject at the end. The other ones are 35' long with only 100 pixels at most in the runs so no injection needed on those runs. So I think just need 4 supplies.
What about my other questions about the connectors?

