Falcon controller s...
 
Notifications
Clear all

Falcon controller setup for pixel tree

12 Posts
4 Users
2 Reactions
1,051 Views
Mudsculpter
Posts: 1209
Admin
Topic starter
(@mudsculpter)
Member
Joined: 19 years ago
[#58818]

I just want some eyes on the controller setup to ensure I've got things done correctly.
I have seed strings of 146 pixels running from each output up to the top and back down to terminate on the next string down. 73 up... 73 down. Is the configuration shown correct? If not please advise...

Falconcontroller

11 Replies
Posts: 429
(@mikekrebs)
Reputable Member
Joined: 12 years ago

I don't know the falcon but if you have 146 pixels on port 1 and a different string of 146 on port two and both go up 73 and down 73, then the direction should be the same. Somewhere in Vixen, you would tell it that the string zigzags at 73


Reply
Mudsculpter
Posts: 1209
Admin
Topic starter
(@mudsculpter)
Member
Joined: 19 years ago

Thanks... it looks like the majority feels this setup is done in the patching routine


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Set all of your ports forward. Set the zig-count value to 73. It will break your string into a virtual string with the 2nd halve going in revers. No need to change the patching.


Reply
Mudsculpter
Posts: 1209
Admin
Topic starter
(@mudsculpter)
Member
Joined: 19 years ago

This is a great solution... I like it


Reply
Page 1 / 3
Share: