Anyone know how to troubleshoot and see if a four string diff receiver is actually receiving data? I have an f48 that I can't seem to get any out from.
Have you tried another good cat 5 cable?
Do you have another receiver board to swap with?
Does test mode on the F48 do anything?
Are you using 3 wire pixels? (ie 2811)
I have two receiver boards and neither is working so haven't swapped cables.
I do have another receiver still in package oncouod test.
Test mode does nothing
Three wire
Have you double checked both the wiring on the plug on the receiver board and the wiring of the pixels?
Does the power light come on on the receiver board?
Got pictures of your setup?
Here is my longer detailed post from the falcon forum, which hasn't had any responses....
I had everything up and running a couple of nights ago. We had a bad storm that knocked over the megaTree causing be to put it all back together. It was lightning very bad that night, but I unplugged the power on everything fairly early in the night. I did not however remember to unplug the f48 itself, which is in my garage. Now that I have everything back up, I can't get any output from the two differential receivers attached to the f48. I can put it in test mode and get no output from any of the attached devices. I unplugged everything two one of the receivers after the storm, so I could see that maybe I didn't attach it back correctly, but I didn't detach anything from the other board so nothing changed on it or the f48.
On the f48 UI, I can see the packet count increase for the universes. How can I troubleshoot if anything is actually being sent to the receiver boards? Should there be some blinking or anything on the boards (the lights are all solid on the fuses).
FYI - I've also gone ahead and reflashed firmware as well as reloaded the settings just to be sure.
