Failure Analysis
 
Notifications
Clear all

Failure Analysis

10 Posts
7 Users
0 Reactions
5,655 Views
Posts: 58
Topic starter
(@wood-guy)
Trusted Member
Joined: 15 years ago
[#50526]

This was my first year using some pixels on driveway arches. I did a test run at Halloween on my porch railing with 100 pixels. At Halloween I got a failure on a pixel after a long period of rain. Over Christmas I had some failure too. I realized that water was somehow getting in the pixels. What I noticed is the wires were breaking the surface tension of the water. This lead me to spray down the pixels with some silicone boot waterproofer. That caused the water to bead up and then I noticed less problems when it rained. I replaced one particular pixel that was still acting up after taking everything down and drying it out. Below are pictures of what I found after cutting the bad pixel apart. Water was clearly get in. I suspect that capillary action was drawing the water in around the wires. The node were IP67. I could have avoided all this if I would have seen the IP68 nodes when ordering. DOH! I'm going to try and limp along one more year. I plan to use some acrylic conformal coating in an attempt to seal up the nodes where the wires enter.

20190121 132615 smaller
20190121 132604 smaller
20190121 133607 smaller

9 Replies
Posts: 486
(@uncledan)
Honorable Member
Joined: 11 years ago

Very poor design on those... Sorry about all the issues. I have several thousand C9's (Pixabulb Style) on my house outline. NO failures in 2 years. I would toss those and start over myself. I hate repairing stuff and having issues


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago

I have used Pixabulbs for years with constant failures and need for pixel repairs.

This year I started using the Pixabulbs that I bought during the 2017 presale in the hopes that they had been improved. I experienced even more failures very soon after I started my display, even though I had tested them all and even ran them to try and detect infant mortality. Rain seemed to affect these as well.

When you live in the Northeast, on a ladder in the cold trying to splice in replacement pixels it just isn’t fun.

I also had four spare strips so I could more easily replace bad strips on my mega tree, and quickly used all of those.

Hope others have had better luck with theirs.

My bullet and square pixels had very few failures.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

My son has used some spray-on liquid tape and is now recommending I use it on my lights.....maybe this is a fit for you too.

Black Spray Liquid Tape 6 oz

lqt

https://www.homedepot.com/p/Gardner-Bender-Black-Spray-Liquid-Tape-6-oz-LTS-400/202906380


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

squirt some corrosion X in there. It should keep the water out.


Reply
Page 1 / 2
Share: