Failure Analysis
 
Notifications
Clear all

Failure Analysis

10 Posts
7 Users
0 Reactions
5,660 Views
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago
MartinMueller2003 wrote:squirt some corrosion X in there. It should keep the water out.

I didn't see any claims in the Corrosive X brochure claiming to be a water seal product. Need to keep water out when possible.


Reply
Posts: 844
(@ags0000)
Noble Member
Joined: 16 years ago

I wonder if the intrusion isn't through/along the wires as it enters the molded body, but instead from the front. The bulb isn't a waterproof seal, and the LED (diffusing lens) protrudes from the pixel body and is only sealed with silicone. It seems to me that with temperature flux, expansion/contraction around that interface may be allowing water in. I purchased a few strands of that very type from Ray a year ago as a test before a much larger purchase. I did not end up going with them for two reasons: 1) the concern about waterproofing around the LED as noted above, and 2) the lenses would fall of at the slightest motion. Not at all acceptable when outside on a 30' tall megatree.

Good luck with your research and solution.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

it is gun oil. i use it on my connectors and anyplace i want to stop water effects. i coats metal surfaces and prevents water from interacting with the metal. no it does not keep the water out but it does keep the water from having an effect. i have found you cant stop water from getting in but if it has no impact once inside, then who cares. 🙂


Reply
Posts: 299
(@dcamron)
Reputable Member
Joined: 10 years ago
blantrip wrote:I have used Pixabulbs for years with constant failures and need for pixel repairs.

I've never had a pixabulb failure but did see quite a few that had water in the lens. They were hanging with the lens pointed downward and we had 7-8 days of constant rain. None of the bulbs failed because water didn't get into the epoxy puck. I think water flowed down the wire and into the pixel body.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago
dcamron wrote:I've never had a pixabulb failure but did see quite a few that had water in the lens. They were hanging with the lens pointed downward and we had 7-8 days of constant rain. None of the bulbs failed because water didn't get into the epoxy puck. I think water flowed down the wire and into the pixel body.

I think you should consider putting a drip hole in those lenses, so the water can drain


Reply
Page 2 / 2
Share: