ESPixelStick Progra...
 
Notifications
Clear all

ESPixelStick Programming Help

32 Posts
6 Users
0 Reactions
8,955 Views
Posts: 125
Topic starter
(@mmais68569)
Estimable Member
Joined: 17 years ago
[#51670]

I am trying to program my ESPixelStick with Travis so I can adjust the brightness but every time I try to open the Jar File I get this error message. I have tried IE, Chrome, Brave and none of them work. What can I do to solve this problem?
Mike

Error 1
Error 2

31 Replies
Posts: 103
(@lugnut68f)
Estimable Member
Joined: 10 years ago

I think you must have the correct Java software. Have you tried installing or updating that?


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

You do need to have Java installed, does not need to the be the latest but at least 8.x. And all you need to do is run the ESPSFlashTool.jar file


Reply
Posts: 125
Topic starter
(@mmais68569)
Estimable Member
Joined: 17 years ago

I am using the latest update.
Mike

update
Installed
Allowed

Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago
mmais68569 wrote:I am using the latest update.
Mike

Cannot run in compressed form...must extract to a directory then execute ESPSFlashTool.jar


Reply
Posts: 125
Topic starter
(@mmais68569)
Estimable Member
Joined: 17 years ago

Thanks Mr. Grumpy I was able to get into the controller & reset it but could not program. I have a v2.0 board with a reset & program button. The directions to program I used this spring seemed different.
Mike

Fail 1
Fail 2

Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

They look the same as I have been using. As I read your posted errors, it may be you did not get into program mode. I tell people to hold the program button for 1-2 second after releasing the reset button. Another common problem solver is to flip the Rx and Tx on your PixelStick Could be Rx to Rx and Tx to Tx -or- Rx to Tx and Tx to Rx.


Reply
Posts: 125
Topic starter
(@mmais68569)
Estimable Member
Joined: 17 years ago

Do I click the upload button before or after releasing the Program button?
Mike


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

Sorry for the delay....after release of program button


Reply
Posts: 125
Topic starter
(@mmais68569)
Estimable Member
Joined: 17 years ago

Still not able to program. I am trying to reprogram an existing PixelStick that had a previous version on it with a static IP address. When I went to reprogram I did not change the controller back to a DCHP ip address so it looks like when I try to program it is looking for the old static IP 192.168.1.148. Could this be the problem & if so how do I correct?
Thanks Mike

error 3

Reply
Page 1 / 4
Share: