Did you connect the groung (-) from the dig and the 12v ps? The ground that the data device is connected to must be connnected to the ground on the st...
This is the only manual I know of but but the setup is basically the same for all of the Kulp controllers. I have used it for the 4, 8, 16, and 32 jus...
Go to this link, At the bottom there will be 2 files one called release archive, download it (you will have to be logged in to download it). Unzip th...
Thank you Shelby and Martin. I've been following this thread and trying to get the newest version up and going. Just to help others out, I had to be l...
Someone on this forum did a great writeup description of the difference in resistor vs. regulated pixels. I can't find it now but if I remember correc...
The output configuration on the bottom of the screen is where you set your outputs. Set the outputs to use to 4 on all 4 of the banks. You only have 1...
Hi Martin, Hate to be a bother but that link didn't work for me. I found the jar file in the dist folder but that don't find the firmware for some rea...
Yes, you can change and update controllers about any time you want to change them. More important to me to get started is to get the house layout and ...
If you use a $25 espixelstick you can put it where you are standing, put your power supply where the garage door is open and do all your injection fro...
Is the IP address on the pixelstick set the same as the controller setup in xlights? It has to send the data to the correct address for the stick to b...
And if anyone wants to do Scott's upgrade to the 682 I bought 5 boards and only need 2 at most. It was cheaper to buy 5 so have 3 extras.
If that deal falls through I have a couple of Ron's Picaps and Ron's piMatrix boards I'm going to be sending down the road. Message me if you need one...
I want it. Will pm you now. No shipping, pickup in person.
