jchuchla wrote:you should always use multicast for sACN over WiFi.
https://www.diychristmas.org/wiki/index.php?title=Streaming_ACN_over_WiFi
I'm just giving this a read now 🙂
It's alive!!! I have successfully converted to Multicast. There is still a slight "lag" when the megatree is displaying fast effects, but I'll just need to live with it. Now to reconnect my Rasp Pi... 🙂
Oh, I did have one more question.
Even though xlights is outputting to the controllers, shouldn't the area in the image not be greyed out? When I have the output to lights de-selected, only the delete key in functional and the light stays grey, not red or green. It's like xlights cant see the controllers, yet it works.
Update on the "lag" My Matrix and Megatree both have a controller refresh rate of 63ms. I've been building my sequences in 25Ms. So I did a test sequence with the butterfly effect (which would normally lag and speedup etc.) at 65ms, I ran for 2 minutes and the lag appeared to disappear. I think this is a small price to pay for this year, as my sequencing skills aren't all that hot anyway. Perhaps I'll run 2 esps on each of these props next year to help bring down the refresh rate.
Are you using Nodemcu or a Wemos D1 ?
There's another thread over here that's having a very similar conversation: https://diychristmas.org/vb1/showthread.php?10775-Lag-with-FPP-Loco-M2-and-static-ESP-s/page3
25ms is not going to happen on WiFi. That requires double the data as 50ms. Which means you'll be able to use half the universes. You'll be lucky to get 6-8 universes working at 25ms on an untuned network. And the data is never going to actually go out to controllers that fast anyhow. In general, it's best to keep your sequence rate evenly divisble of your AP's beacon interval, which is 100ms in most cases. So 50 or 100ms will work best. You can get in the high teens with 50ms and an average network. To get beyond that, you need to be well tuned and interference free.
angus40 wrote:Are you using Nodemcu or a Wemos D1 ?
D1 MINIS
Sent from my YAL-L21 using Tapatalk
townshend lights wrote:D1 MINISSent from my YAL-L21 using Tapatalk
The D1 should be the standard . 🙂
I have a couple of the nodemcu v1.0 and they seemed sluggish compared to the D1 .
So Ii went with the D1's and just use the the nodemcu's for breadboarding projects.
angus40 wrote:The D1 should be the standard . 🙂
I have a couple of the nodemcu v1.0 and they seemed sluggish compared to the D1 .
So Ii went with the D1's and just use the the nodemcu's for breadboarding projects.
For ESPixelSticks, the Original used the ESP-01

