ESPixelStick Flash ...
 
Notifications
Clear all

ESPixelStick Flash Tool

223 Posts
49 Users
0 Reactions
100.2 K Views
Posts: 93
(@kockie)
Trusted Member
Joined: 11 years ago

what's wrong with the ali-express esp's? I have different type of esp's all from different ali-express vendors; i think about 40 in total. They all programmed and work fine.
As I recently found out... you should not reverse polarity :biggrin2::biggrin2:. Cost me 3 esp's. I had one spare and managed to screw it in place with a screw terminal 3 minutes before showtime (150 people waiting:biggrin2:

Where do you live in the Netherlands?


Reply
Posts: 7
(@mdnooyer)
Active Member
Joined: 9 years ago

Found out that on the working ESP'S "Al-Cloud inside" stands on the print. Have 10 working ESP's ( from diverent shops incl ALi) but with the last 20 ESP's if have this problem. All the others i don't have a problem. use the same programer and flash file.


Reply
Posts: 1115
(@11bravo)
Noble Member
Joined: 14 years ago

I flashed 10 ESP-01S. I assume the router assigns them a address. I need to know how to assign them a address manually because all but one have a duplicate address.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
11Bravo wrote:I flashed 10 ESP-01S. I assume the router assigns them a address. I need to know how to assign them a address manually because all but one have a duplicate address.

If the router assigned them an address, then they would not get duplicate addresses. It sounds like your image does not have DHCP enabled. The original versions had a place where you could set the address at compile time. You can also bring them up one at a time and set the address via the web interface.


Reply
TheLost
Posts: 189
(@thelost)
Estimable Member
Joined: 10 years ago
mdnooyer wrote:I think i found a problem, look with a microscoop to the ESP and foud out that all off the ESP i orderd by Ali express won't work.
The others i buy in the Netherlands works fine.
I did them in the same box, now i sort them to look on the print and saw some diverence so i can sort them.

Just FYI... I've had a similar problem with a few ESP-01's I picked up on Amazon. If you change any of the settings and save... the config.json gets corrupt and the board stops working. On mine, the power light just flashes blue when this happens. I've stepped through the code and it fails in loadConfig (logs a ' Configuration File Format Error ').

It looks like there are some ESP-01's that can't handle modifying anything in SPIFFs? i plan on writing a quick test app this weekend to see whats going on.

You can get around this problem by modifying the config.json file ('spiffs' folder in the flash tool) with all your settings then upload.


Reply
Page 36 / 45
Share: