ESPixelStick Flash ...
 
Notifications
Clear all

ESPixelStick Flash Tool

223 Posts
49 Users
0 Reactions
100.3 K Views
sporadic
Posts: 1199
Topic starter
(@sporadic)
Noble Member
Joined: 14 years ago
blantrip wrote:The problem I mentioned about last year's ESPixelsticks not connecting has been solved. I have to admit my own stupidity. Since I was having the problem flashing new ESPixelsticks, I thought I had a problem with my other ones as well. Turns out, the ip address that I wrote on the first arch I tried was incorrect. Once I used the correct ip address, all is well with those.

Now about the new ones I'm trying to flash and assign a static ip to. Attached are screen captures of what I see when I first flash it, and then what I see after assigning a static ip address in the serial monitor window.

It's been a while since I've tested static IP's, I'll look into this evening.

worksopian wrote:

Not sure what, if anything, I did different but it works now!?

Good to hear, let me know if you run into any other issues.
thanks,
-shelby


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago
sporadic wrote:It's been a while since I've tested static IP's, I'll look into this evening.

Good to hear, let me know if you run into any other issues.
thanks,
-shelby

Thanks. I’m good at the moment. In lieu of setting a static ip, I’ve reserved the DHCP assigned ip address in my router configuration, so it should work ok during the show.


Reply
Posts: 7
(@mdnooyer)
Active Member
Joined: 9 years ago

i have the same problem, i have build 4 and they work fine, can change the ip and name. but now i can't change the namen and ip. when i do that, i can't connect the stick.
When i flash him again it's works fine but, can't change anyting.


Reply
Posts: 7
(@mdnooyer)
Active Member
Joined: 9 years ago

Can't find the problem. i use the same programmer, and the same file. I have 3 types off ESP and try them all. Now i take one that works fine. program it again and have now the same problem with this one.
Now i only have 3 thats works fine. the ohter one i can program, but when i change something name or ip adres than it won't work anymore. When i change the universal channel or pixel counts its not a problem.
i see this on my programmer

ets Jan 8 2013,rst cause:4, boot mode:(1,0)

wdt reset


Reply
Posts: 7
(@mdnooyer)
Active Member
Joined: 9 years ago

I think i found a problem, look with a microscoop to the ESP and foud out that all off the ESP i orderd by Ali express won't work.
The others i buy in the Netherlands works fine.
I did them in the same box, now i sort them to look on the print and saw some diverence so i can sort them.


Reply
Page 35 / 45
Share: