SPIFFFs come in two sizes (as does code memory). You may have gotten a batch of the smaller ones.
I'm not very savvy on router workings and wished that I were more smart on it, but here is what I have experienced. Between the time that I programmed the first batch, and the the second batch the router power had been turned off and back on and disconnected from PC as well during that time. So I guess it reset the routers start addressing sequence over. If I change that parameter from 10 to say 20 in the router, then the next ESP-01 that I connect to will start at 20 and the next will get 21 and so on until I unplug the router and it starts over at 20 when I resume programming again. If I change it to start at 10, the next ESP-01 will be programmed 192.168.1.10 next one will be 11 next one will 12 and so on. If I change it to 100 then the next one will be set at 192.168.1.100, 101, 102 ,103 ,104 and so on.
I tried changing the address in the ESP-01 web page when I unchecked the box USE DHCP.
I change the address and Save it, the result is the led on the TTL adapter and the ESP-01 continuously blink. I can pull the adapter from the USB port, wait a bit and plug it back in, the leds are still blinking.
I have to open up the router web page and set the start number in the router just like I did in the ESP-01 web page and do a reprogram for it will let me back into the ESP-01 web page.
It is really hard to put everything down in words here when trying to explain what goes on.
The start address sequence that I start with in the router works for me, so as it is, I'm staying with it.
I still have work to do outside before I can even get the first sequence going so I better get out there and do something.
Thanks "The lost"
That was a golden tip.
it works fine now, i hope i have to program them once.
Greetz, Mark
{
"network": {
"ssid": "your network name",
"passphrase": "your network password",
"hostname": "",
"ip": [
192,
168,
3,
63
],
"netmask": [
255,
255,
255,
0
],
"gateway": [
192,
168,
3,
1
],
"dhcp": false,
"ap_fallback": false
},
"device": {
"id": "ESPixelStick63"
},
"e131": {
"universe": 63,
"channel_start": 1,
"channel_count": 512,
"multicast": false
},
"pixel": {
"pixel_type": 0,
"pixel_color": 0,
"gamma": true
},
"serial": {
"serial_type": 0,
"baudrate": 57600
}
}
The USP adapter is a serial port. If you open a program like PuTTY or the Arduino IDE you can see the messages coming from the ESP. Those messages will tell you what IP address the ESP is using and anything else that may be going wrong.
I just used this tool to flash a couple ESP modules, one of which I am putting on a Renard-Plus LCC16, It flashes fine, I get the IP, go to the web Interface and all works. but once I disconnect it and plug it into the controller, or just back into the PC, it never pulls the IP again. What gives? am I missing a step?
