I 3D printed a star, put my pixels in, and connected a Pixel Pops Tiny. I am getting random pixels coming on. If it is receiving data from FPP, it is ok, but when sitting idle, random pixels.
v3.1 dev is on the ESP-01. If I look at the diagnostics page when the random pixels are blinking, I see no data. But when sent from FPP, I see the colors/data on the web interface.
Using WS2812 pixels and a 5v wall wart from my GECE's.
Any ideas/suggestions?
Found the problem. The 5v power pack from the GECE's was actually a little high. Used one on some older pixels and they work fine. Newer pixels must want it closer to 5v. Put it in my power supply at 5v, worked great and the random pixels firing wet away. Got another power supply that was at 5v and all is good now!
