e682 ZigZag questio...
 
Notifications
Clear all

e682 ZigZag questions

8 Posts
5 Users
0 Reactions
2,364 Views
th182
Posts: 159
(@th182)
Estimable Member
Joined: 11 years ago
Aurbo99 wrote:I'm using firmware 5.xxx beta

I removed the zigzag configuration on the e682, used Vixen to reverse map the 33-64 nodes on each string, this appear to work

EDIT: I reverted back to V4 using the Prop Plug. Zig zag is working again. Thankfully this controller is dedicated to a pixel tree so I can stand to only be able to set the outputs by group.

I am experiencing the same issue on my e682 with version 5 beta firmware. Been trying to revert to version 4 with no luck. Thanks for the idea to reverse patch in vixen! That's going to be my ticket to save the show! I have a mega tree with 18 strings of 100, each on a e682 port, zig-zag at 50 to get 16 vertical strings. If I enable the zig-zag in the e682 I get the duplicate string activity you describe.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago
th182 wrote:EDIT: I reverted back to V4 using the Prop Plug. Zig zag is working again. Thankfully this controller is dedicated to a pixel tree so I can stand to only be able to set the outputs by group.

I am experiencing the same issue on my e682 with version 5 beta firmware. Been trying to revert to version 4 with no luck. Thanks for the idea to reverse patch in vixen! That's going to be my ticket to save the show! I have a mega tree with 18 strings of 100, each on a e682 port, zig-zag at 50 to get 16 vertical strings. If I enable the zig-zag in the e682 I get the duplicate string activity you describe.

I revert back and forth between firmware constantly and never had an issue using a prop plug. I also had issues using zig zag on the 682. I switched to reverse patching in Vixen.

Sent from my SM-T710 using Tapatalk


Reply
th182
Posts: 159
(@th182)
Estimable Member
Joined: 11 years ago
pmiller wrote:I revert back and forth between firmware constantly and never had an issue using a prop plug. I also had issues using zig zag on the 682. I switched to reverse patching in Vixen.

Sent from my SM-T710 using Tapatalk

My firmware swap problems were self induced... Was using the wrong pins on the controller! I went back to 4 and zigzag works as expected.

Sent from my iPhone using Tapatalk


Reply
Page 2 / 2
Share: