I have two e682s in my show, I added the second one last year. I've never had any issue with the first one, I added the second one last year to run a pixel matrix. I noticed last year that from time to time, that controller wouldn't start up correctly - the 3 power LEDs would come up, but the green and red LEDs above wouldn't come on. It was not really repeatable - sometimes it happened, sometimes it didn't. When it did happen, I couldn't come up with any way to make it reset itself... I've tried cycling power, checking the Ethernet connection, validating the eeprom jumper (this is what the troubleshooting guide recommends), but nothing worked repeatedly. The odd thing was that sometimes it would come right back on, sometimes I'd leave it powered down for an hour and it still wouldn't come back on - I was frustrated, but ran out of debugging time, and just left it to chance - sometimes the matrix ran, sometimes it didn't.
This year, all of my early pre-tests I didn't have any issues, but I didn't run full sequences, just tested channels while testing pixel strings. I checked over connections, tightened things up, etc, and was hopeful last years troubles were gone. Now that my show has started up (last night was my first run), the controller has again started giving intermittent issues. Same problem, LEDs for power come on, but it seems to be losing the communication. I know there's power, because sometimes it 'stops' in the middle of a sequence and leaves pixels on frozen at a point in time. I find myself going back to what I was doing last year - cycling power, jiggling the Ethernet cable (I've also replaced the Ethernet cable), replacing the eeprom jumper, but either it comes back on or it doesn't. As I write this, I've taken power off - i'll go back out when finished writing this and hope that it will come up and run for a bit. Just to clarify - this controller does work as intended, sometimes... when it's running it looks really good:) (it's not a matrix anymore, I didn't like that - I ended up using it for a second pixel tree)
Any ideas - I'm thinking something loose or bad solder around the network interface. I'm thinking with the LEDs not coming on that could possibly help point me to a troublemaker? I've got another e682 on the way that hopefully arrives soon enough that I can stop pulling my hair out, otherwise I'll be bald before Santa comes.
Thanks for any ideas.
in case wasn't clear, when it does work, the green and red LEDs do come on - not sure if that was clear after re-reading what I typed.
Verify that your power settings jumpers are correct or making good contact. That is one idea.
Are you running 5V or 12V pixels/power.
http://sandevices.com/documents/E682_Operating_Manual.pdf
I'm running 5V pixel power. Also, it's board rev 1.3 - I notice that it's slightly different than my older one (the one with no trouble) which is rev 1.1.
EMKLLK wrote:in case wasn't clear, when it does work, the green and red LEDs do come on - not sure if that was clear after re-reading what I typed.
I think you have an intermittent connection somewhere. You might try removing (very carefully, the pins are easily bent) all of the socketed chips and reseating them. If no joy there, you could re-flow the solder joints on the upper (control) half of the board. If you are not comfortable trying to re-flow the solder joints, I would be glad to do it for you. I have built 4 of them........
