I'm trying to get a string to work on output 4-1. I have a 50px string on 1-1,1-2,1-3 and they work fine. Based on the channel count i figured the 4-1 plug would start at output#1533 which is universe #4. I can't figure out what I'm doing wrong.
Here is the setup.
Universe-1, 1-510
Universe-2, 511-1021
Universe-3, 1022-1532
Universe-4, 1533-2042
You have to get your mind wrapped around how things work.
The Vixen screen tells Vixen how to map the Vixen channels to the E1.31 universes.
The E682 screen tells the E682 how to map E1.31 universes to E682 outputs. They are two very different things, and if you try to mix them, you'll get all confused.
Your Vixen mapping shows that the first 510 Vixen channels get mapped to Universe 1, the next 510 Vixen channels to universe 2 and so on. That looks OK. Recognize that you've only told Vixen to output 4 universes worth of data.
On the E682, you have told it that you have 4 strings of 50 pixels each on output bank 1. One string on each output. That's 200 pixels or 600 "channels". These will take up all of universe 1 (510), and the first 90 channels of universe 2.
You've also told the E682 to map 4 strings of 50 on output bank 2, 3, 4.
Output 2-1 is mapped to E1.31 channel 91 of universe 2. This would be pixel 201 and Vixen channel 601.
If you've stayed with this, you'll notice that on the E682, output 4-1 starts at universe 4, channel 271. That should map to Vixen channel 1801. As of right now, with the way you have Vixen setup, you can't control all the strings connected to output bank 4, since some of those are mapped to E1.31 universe 5, and Vixen isn't outputting to that universe.
Does that make sense?
Mark,
All of that makes sense and i got it working, well explained, thanks.
What do you do if the strings are not the same length? Do you skip numbers in the Vixen patching?
I plan to run multiple E682 and I recall reading somewhere that in Vixen you only add 1 controller and just increase the channel count? So if I run 2- E682 I just set the channel count to 12,240 and then since I'm using Unicast, just create another set of 1-12 universes with a different IP address.
thanks for the help

