E682 Pixel tree uni...
 
Notifications
Clear all

E682 Pixel tree universe problems?

12 Posts
5 Users
0 Reactions
3,997 Views
Posts: 8
Topic starter
(@scarcebigfoot)
Active Member
Joined: 9 years ago
[#47155]

I am running a E682 all 16 outputs. 2 outputs per universe. 1-1 and 1-2 is universe 5, and so on, up to universe 12. Each strand is 50 nodes long. One universe has a total of 300 channels. The problem I am having starts at strand 7. The Bottom 2 pixels of 7 are off. Then strand 9 bottom 2 are off. 11 is missing 3, 13 and 15 are both missing 4 pxels. Have no idea how to fix it. Other than that it looks pretty good!


11 Replies
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

Post pics of your E682 setup and your sequencer's setup


Reply
Posts: 8
Topic starter
(@scarcebigfoot)
Active Member
Joined: 9 years ago

So this is what I got going on.

E682

e682b

Reply
Posts: 8
Topic starter
(@scarcebigfoot)
Active Member
Joined: 9 years ago

Opps, I know in the second pic that the universes on the output page are wrong. I was goofing around in xlights. Here is the current config that I have been running.

e682b

Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

del.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

On your e682 main page try setting the channels for each universe all to 510 .


Reply
Posts: 357
Guest
(@jerry72)
Member
Joined: 13 years ago

You also need to make all your outputs RGB.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

I pondered the color order settings , but they appeared deliberate .
Still the Question lingers ............. Is the last resort the Operation manual ?


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago
angus40 wrote:I pondered the color order settings , but they appeared deliberate .
Still the Question lingers ............. Is the last resort the Operation manual ?

Make sure you make the changes noted. Need to see your setup in your sequencer, too.


Reply
Posts: 8
Topic starter
(@scarcebigfoot)
Active Member
Joined: 9 years ago

I adjusted all the color outputs based on LOR’s hardware control pixel test console. In this config the colors are all correct and work great in LOR Pixel Editor. Before I did that the colors were all over the place.


Reply
Page 1 / 2
Share: