Yep, I goofed in xlights when I put 512 as last channel. I haven't had time to change it today. Nor the router info that you suggested either.
http://doityourselfchristmas.com/forums/attachment.php?attachmentid=24026&d=1400128973
http://doityourselfchristmas.com/forums/attachment.php?attachmentid=24214&d=1402537565
Ok, I got xlights set up straightened out and Pixels perform as they should. so far from the xlights test. Now to get sequence operating.
I did the changes you suggest to the bridged router, the one connected to the E682.
I paged thru the setup pages and don't see or I over looked it, where to set security encryption.
Glad all is working now!
Was looking at your screen shots there, was there anything under the wireless security tab? Not sure if under the "Advanced Wireless Tab" if you need to change "Authentication Type" from "auto" to "shared key" to enable it?
Might have to do some playing there to figure out where it is, just be sure to back up and save your working set up before you poke around too much so if something messes up you can just do a reset and just upload the working file again quickly.
I found where to change the security encryption.
Setup
Wireless
Wireless Security
Security Mode>>set to WPA2Personnel
WPA Algorithms>> set to AES
WPA Shared Key>> xxxxxxxx
Awesome, now the fun begins!
