I can't seem to access the controller unless I do a force. Once I'm in I can change the address, and save it. But it has no effect. I still can't get in with the new address. Only way to get in is by 169.254.74.73, but if I power it down then back up, or push reset I have to do a force to get back in.
http://doityourselfchristmas.com/forums/attachment.php?attachmentid=24174&d=1402262466
make sure your PC network has a static address that is in the 192.168.1.x range . It sounds like your PC is trying to DHCP a address and getting the number as a default...
Also if you are trying it with the 682 directly connected to your PC you will need to static the address of your PC after you change it.
WHat firmware is your device?
If it is 4.XX.XX check out the link below.
It is different than 3.xx.xx
http://sandevices.com/documents/E68X_Version_4_Firmware.pdfhttp://
DHCP is only achieved through a router. Your PC cannot assign a DHCP address.
If you are static (Fixed address) your PC needs to be on the same sub net as your new assigned address of the E682 with the last octet a different number.
I had to restart my E682 for the new address to set.
I got mine stuck at some lost address. Reset and counted 15 blinks and found it at 192.168.10.206. (My E1.31 network is 192.168.10.xx)
Also set your mask to 255.255.255.0.:biggrin2:
E682 Firmware is 4.033
My original plan was to use a Desktop PC, but I could not even get in the E682 with it. It does not have anything like the laptop IP configuration, such as a address like 192.168.x.x
