Notifications
Clear all

E681 12v help .

4 Posts
3 Users
0 Reactions
2,442 Views
Posts: 8517
Topic starter
(@angus40)
Illustrious Member
Joined: 15 years ago
[#20515]

I have 1 e681 that worked great with 5v .

changed over to 12 jumpers on a , c .

powering via j17 and j18 all i get is both pixel power leds on and a dim 5v ok led .

in Jims opman He states this is an onboard power supply failure .

Could some 1 help me with this .

Retested with 5v and same issue 🙁

Thanks

Richard


3 Replies
Posts: 17
(@crazydave)
Active Member
Joined: 14 years ago

I just got a e681 and a 12v ps I didn't change any jumpers from how it was shipped. Works fine. I will double check my jumpers and manual when I get home

Sent from my C771 using Tapatalk 2


Reply
Posts: 74
(@cscool36)
Estimable Member
Joined: 16 years ago

You can also check by using A & D with ext power on J19 plug.(12 volts).
I use this option to keep the E1.31 on and turn off the 5volt power supply for the pixels when not needed
Hope this Helps
Colin


Reply
Posts: 8517
Topic starter
(@angus40)
Illustrious Member
Joined: 15 years ago

Solved . I had a bad solder on ( ground pin ) of the 5V DC-DC Converter OKI-78SR-5/1.5-W36-C: , thanks to jim's manual i Had a good idea where to trouble shoot .

This is a 3 pin part and the center pin was weakly soldered.

Fortunately i have other e681's that required assembly so i populted one of them and swapped all the chips from the troubled board to rule out any failures there with 12v

after verifying the chips were all working on the new board i new where to look on the troubled board for issues .

as stated in jims manual >> the onboard power was most likely the source based on the onboard troubleshooting leds .

hope this helps any of you that may experience this issue also.

while testing the e681 with 5v this issue did not appear it was when i changed over to 12v .

Cheers
Richard


Reply
Share: