Notifications
Clear all

E6804

4 Posts
3 Users
0 Reactions
1,522 Views
Posts: 431
Topic starter
(@dkelly0802)
Honorable Member
Joined: 11 years ago
[#47283]

Anybody else have any problems with they're sandevice e6804 freezing up. Everything will be fine trying to configure the ports and all of a sudden it will not let you change the parameters. It goes back to what it was previously set to. Same thing happens in test mode it won't let me turn test off or change pattern. The only thing it will let me do is reboot the controller so I know there's some kind of communication. Any ideas?


3 Replies
Xenia
Posts: 1358
(@xenia)
Noble Member
Joined: 15 years ago

I assume you upgraded to firmware 5.030? I am having the same problem. Anytime I hit update system information, the web server locks up and will not let you back to the web server. My solution was to boot into a default ip such as 192.168.1.206 as a temporary ip and make all changes I can and the last thing to do is put in the actual ip and hit the system update button. I then go in again as the temp ip of 192.168.1.206 and see if everything is ok. If it is, I change wring back to show network and hit the program button once and the system seems to work from there.


Reply
Posts: 20
(@joshuagray)
Eminent Member
Joined: 16 years ago

I'm having the same issues with the network response to the config web interface. I have multiple 682 & 6804's and a couple of them started doing it after going to the 5.030 code. If I wait about 3-4 minutes the web interface comes back and I make another change. Sometimes I can make 2-3 changes and save before I have to wait again. Everything else seems to work fine, show still runs fine.


Reply
Posts: 431
Topic starter
(@dkelly0802)
Honorable Member
Joined: 11 years ago

Ok thanks... I'm not the most patient person but I will try that the next time I fire it up. Another question how many pixels can the 6804 drive? I know it's 2040 but is that divided by 3 for each led for 680 or is it 2040 rgb nodes? I'm a little confused. Thanks


Reply
Share: