Notifications
Clear all

E-682 Problem

5 Posts
4 Users
0 Reactions
1,675 Views
Posts: 43
Topic starter
(@dicklinn)
Eminent Member
Joined: 14 years ago
[#39792]

Looking for some help on a problem with an E682 Controller.

Groups 1, 3. and 4 of 4 outputs all work perfectly. Group 2 all 4 outputs though is giving me trouble. The pixels in that group are coming on all white, whether the show is running or not. If I open the controller to look and feel around for a bad connection, it may start working, but only for a short time before they go all white again.

Here's an example: I can power the controller down and back up. When it is back on, group 2 of lights all come on white. Then I set the test patter to run. All other groups run as expect. But all in group 2 stay white.

Two days ago it was running perfectly.

Has any one run into this problem, or have any ideas?

Richard


4 Replies
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

Check the resistor packs for those outputs. Wiggle each pack to see if they are loose.


Reply
duramadmax
Posts: 904
(@duramadmax)
Noble Member
Joined: 16 years ago

also if the universes have not been set in the firmware, you will get lights on


Reply
Posts: 43
Topic starter
(@dicklinn)
Eminent Member
Joined: 14 years ago

Yes, the firmware is correct and I did swap the resistor packs as well. No change.

However, I just noticed that if I move or do anything near the cat-5 cable and it moves slightly that seems impact the performance of group two. Can the wiznet module cause this kind of problem?


Reply
gassy
Posts: 548
(@gassy)
Honorable Member
Joined: 17 years ago

Is it time to re-flow solder connections? Especially if you move a board component and it effects the operation.


Reply
Share: