Data & Power over C...
 
Notifications
Clear all

Data & Power over Coax (?)

12 Posts
6 Users
0 Reactions
9,107 Views
Posts: 54
Topic starter
(@piense)
Trusted Member
Joined: 14 years ago
33fcc142 5360 4ac6 b0d3 434c33823563

I built this idea out and it actually seems to be working. The bigger square board is receiving pixel data & power over 50' of coax. The theoretical length limit for the data is around 1000', power is limited by the current capacity of the wire. The PSU is rated at 90 watts, not sure if it'll do that once it's in an enclosure outside. I plan to box it up and leave in the Texas sun one afternoon and see how it does. The receiver can theoretically report temperature, voltage, and current consumption back to the transmitter, haven't got all the code and logic for it yet. The idea is to allow the pixel configuration to be stored on the receivers so that it doesn't matter what port things get plugged into on the controller. The little board is a prototype of the transmit circuit - didn't want to pay for a large PCB with a planned 8 transmitters quite yet.


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

It has been several years, but using Coax has been accomplished before. Do a search on each of the sites (especially the Aussie site). I remember they had good results, with distances we could not accomplish using other wiring methods.

As far as power over it, as you have seen, is quite possible. The shield can carry far more than you think. The center conductor is your limiting factor. Some of our coax cable has a pretty small center conductor, while others have what I can only describe as 16 AWG.


Reply
Page 2 / 2
Share: