Data & Power over C...
 
Notifications
Clear all

Data & Power over Coax (?)

12 Posts
6 Users
0 Reactions
9,104 Views
Posts: 54
Topic starter
(@piense)
Trusted Member
Joined: 14 years ago
[#51488]

I’ve been pondering ways to combine power and data into a single cable and eventually ended up looking at coax after figuring that 802.3bt isn’t mature or cheap enough. Looking at data sheets it really looks like you could send 48 volts and 100 mbit ethernet over quite a distance. Basically it’d be something like the Falcon F48 with its remote receivers but including power. I need to math out the economics considering the electronics are a tad more expensive but I think it’d scale really well. You could have 1 main controller with a dozen coax outputs that feed receivers with say 4 string ports at 100 watt total each at 200’ away.


11 Replies
Posts: 602
Guest
(@bwinter)
Honorable Member
Joined: 10 years ago

Why would you go this route, instead of just using 18/3?


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

You cant get that much current through the cable.


Reply
Posts: 54
Topic starter
(@piense)
Trusted Member
Joined: 14 years ago

I’m guessing you can get two amps through rg6. That’d be ~100 watts at 48 volts. The regulators I was looking at go down to a 20 volt input, so a little voltage drop would be perfectly fine.


Reply
Penfold
Posts: 1235
(@penfold)
Noble Member
Joined: 19 years ago

I know I used Robert Jordans Pixel Hubs in the past that were able to use Cat5e as a power injection and data transfer. It worked brilliantly. However the last couple of years his forum died off because real life got in the way for him.


Reply
Page 1 / 3
Share: