Controlling Two Dif...
 
Notifications
Clear all

Controlling Two Different Pixel Voltages (12V, 5V) from the same controller

4 Posts
3 Users
0 Reactions
1,111 Views
Posts: 3
Topic starter
(@romborna)
Active Member
Joined: 4 years ago
[#56618]

Hello
I am planning to purchase a Holidaycoro 16 channel smart receiver.
Given the number of pixels I am putting on this controller, I am doing power injection. So far so good.
While all my other pixels are 5v, I like to use one of the channels from this controller to address a 5 pixel spotlight set which requires 12V.
Is my assumption correct that I can bring data and ground from the controller that is fed by a 5V power supply, connect the ground to ground, then use a 12V (plus and ground) power injection directly to my spotlight without an issue.
i.e. : keep 12v and 5v systems isolated but common the ground for data transfer from the controller?!

Thanks in advance,
Regards,
Rom


3 Replies
Posts: 128
(@sctwohig)
Estimable Member
Joined: 10 years ago

Yes you can do this, I have done this a few times this year. Its pretty much just like you said. I built a 5v 3Wire pigtail that connects to the controller pigtail and has a 12v 2wire power injection pigtail and a 12V 3wire pigtail. I heat shrunk the 5v positive on the 5v 3wire pigtail so I wouldnt connect it to anything. I then connected all 3 Grounds together then I connected the Data from the 5v 3Wire pigtail to the Data of the 12v 3Wire pigtail. Then I connected the 12v 2wire pigtail positive to the 12v 3 wire positive. Works great with no issues.

Thanks,
Shawn


Reply
Posts: 3
Topic starter
(@romborna)
Active Member
Joined: 4 years ago
sctwohig wrote:Yes you can do this, I have done this a few times this year. Its pretty much just like you said. I built a 5v 3Wire pigtail that connects to the controller pigtail and has a 12v 2wire power injection pigtail and a 12V 3wire pigtail. I heat shrunk the 5v positive on the 5v 3wire pigtail so I wouldnt connect it to anything. I then connected all 3 Grounds together then I connected the Data from the 5v 3Wire pigtail to the Data of the 12v 3Wire pigtail. Then I connected the 12v 2wire pigtail positive to the 12v 3 wire positive. Works great with no issues.

Thanks,
Shawn

Perfect! Thanks Shawn!


Reply
Posts: 49
(@jcommisso)
Trusted Member
Joined: 10 years ago

You could use different connectors for different voltages, like xConnect for 12v and Ray Wu for 5v. That way you don't mix up voltages.


Reply
Share: