Typically the modem or router will be 192.168.0.1 if the dhcp settings for your pc was 192.168.0.5 then manually set the ip of that pc to that ip. Set your 1st light controller to something like 192.168.0.101 , 2nd light controller to 192.168.0.102 and so on. sometimes you have to power cycle everything to get them to sync again shut down everything plugged into router the pc(s), controller(s) etc... unplug router the wait the 30 sec to make sure all lights on it go out. plug router in first then start the pc(s) one at a time, then light controllers. never use xxx.xxx.xxx.000 or xxx.xxx.xxx.255 make sure all the other devices on you net have the same first 3 octs, be it 192.168.0.xxx or 192.168.1.xxx or 10.0.0.xxx then your subnets will be 255.255.255.0.
it can be as long as the first 3 sets of number match and the last set is different you will be fine and yes just connect the 2nd controller and set it up in your sequencer for the ip it is on
thyndman wrote:Ok, one more question. When I add the second controller, I'm guessing the IP address should set to something higher that the first controller. The first one is 192.168.1.50, so the next on could be 192.168.1.60?
Does the second controller just get pluged into the router/switch with the cat 5 cable? My second controller is an alphapix 4, first one is the alphapix16.Thanks
Tom
