Finally getting around to setting this up. The problem seems to be that the pc is set to automatically find IP address. I changed this setting and entered 192.168.0.1 and have no internet connection. I did the ipconfig, ip displayed was 192.168.1.5, When I entered that IP address it still will not connect to the Internet. The ip on the controller is pre set to 192.168.0.50. I think I'm close but just not there yet. What setting am I missing?
Thanks
Tom
you can use the buttons on the controller too change the ip that is set for it change it too something like 192.168.1.??? (I use 206) for mine and let your computer get its ip from router like normal once you reset the controller try too connect to it with the ip address you changed it too
Thanks, will give that a try.
Tom
I changed the IP address of the controller to that of th pc. The controller is still set as a static ip, the pc is set to automatically get ip. Will that make a difference?
I pinged the IP address and all was good. Ran the test in x lights and the strips light up and change colors. I think it may be working.
Thanks for all the help
Tom
Ok, one more question. When I add the second controller, I'm guessing the IP address should set to something higher that the first controller. The first one is 192.168.1.50, so the next on could be 192.168.1.60?
Does the second controller just get pluged into the router/switch with the cat 5 cable? My second controller is an alphapix 4, first one is the alphapix16.
Thanks
Tom
