Connecting addressa...
 
Notifications
Clear all

Connecting addressable strips/strings in parallel

16 Posts
8 Users
0 Reactions
1,034 Views
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

Why 220Ω specifically, and why on the input? Should it be in series or parallel? What is a proper level shifter (as opposed to an improper level shifter)?


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

Ali has splitters and boosters that do this, but they are meant for [indoor] JST connectors rather than XConnects. I have 4 of them, but I rarely use them. So it's electrically okay enough laugh tthat people manufacture hardware to support this, but sharing the same channel that way doesn't let you do everything you might want in Xlights.

LED Strip JST SM 3P Male Female Connection Harness 1 to 2 3 4 Synchronized Wire 2.54mm Pitch 1M 2M 5M Extension Cable 3Pin AWG22
https://a.aliexpress.com/_mPB0iax

Mini LED Signal Amplifier 1-to-2/4/8 TTL Repeater Module for WS2812B/SK6812 RGBIC Strip 3Pin/4Pin Addressable Pixel Lights 5-24V
https://a.aliexpress.com/_mNLn5TD


Reply
Posts: 6
(@dudeiot)
Active Member
Joined: 3 months ago
P. Short wrote:
Why 220Ω specifically, and why on the input? Should it be in series or parallel? What is a proper level shifter (as opposed to an improper level shifter)?

100–470 Ω is common for data‑line series resistors on LED strips. 220 Ω is a good middle value. It helps clean up the signal, reduces reflections, and also prevents the situation where an unpowered strip tries to back‑feed through the data line — the resistor limits that current so you don’t accidentally “power” the strip through DIN.


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

I use such cheap controllers that another channel is no big deal. And I haven't used a single resistor or level shifter on any output. No glitches.


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

I made a couple megatree center poles once with 6 strips of 117 pixels, connected in parallel and they worked beautifully.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I agree. The cost of another pixel capable port is worth the loss of versatility incurred by using strips in parallel.


Reply
Page 2 / 2
Share: