Loose Pixel in coro...
 
Notifications
Clear all

Loose Pixel in coro solution?

12 Posts
7 Users
3 Reactions
850 Views
Posts: 17
Topic starter
(@jaxlax)
Eminent Member
Joined: 5 years ago
[#59161]

I've got some new Hatitude Quartets and using Evo Domes in them and there just isn't any friction between the two items to securely hold the pixels in place. If I pick it up vertically; a few tend to fall out.
Is there any easy fix for this or am I just going to have to be extra careful and vigilant when installing and during the show if any fall out the back?

I thought about running a paint roller across the back to get everything somewhat flat and then either using some painters tape in a grid or using some Press'n'Seal rolled on? Just need a little something to hold them down, but not so much that any repairs or replacements will damage/ruin the prop.

Thanks for any ideas.


11 Replies
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

I won a prop at a Mini that I think was drilled sightly too big for the bullets I was using. I found some thin clear washers on Amazon that I put on the front size to hold them on. That was three years ago. I wouldn't doubt that someone sells sleeves that fit in the hole to shrink it a bit.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Hot glue. But it needs to be refreshed every few years


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

Additional suggestion found here.


Reply
Posts: 17
Topic starter
(@jaxlax)
Eminent Member
Joined: 5 years ago
MartinMueller2003 wrote:
Hot glue. But it needs to be refreshed every few years

That's gonna be a lot of dabs...
697 pixels for 3 props - 2091 dabs. Guess I'll look at the bulk packs of glue sticks on amazon


Reply
Page 1 / 3
Share: