Cheap LED Checker
 
Notifications
Clear all

Cheap LED Checker

1 Posts
1 Users
0 Reactions
953 Views
IdunBenhad
Posts: 1603
Topic starter
(@idunbenhad)
Noble Member
Joined: 18 years ago
[#46361]

Hi:
I needed a way to check LEDs in some strings and net lights that I have. Unplugging, substituting a known good LED and then unplugging it and reinserting was not my cup of tea, and I didn't want to have to check each with an ohmmeter.

So being basically lazy and cheap (El Cheapo is my middle name), I came up with a quick LED checker.

I use a lot of PC power supplies for both my lights and some controllers, so I have a few of the around. (I bought 5 for $20.00 from Goodwill).

Here are the steps. Look at the pics to see how I did it. Sorry about the first one being out of focus, but you can see how I did it.

1. I cut off a male plug from an old string of incans. BTW--it's fused!
2. I bent the prongs as shown with longnose pliers.
3. Mount the plug on a board with a screw so it won't move around when you use it.
4. Connect a 240 ohm resistor to the +5 volts of the power supply and connect one wire from the plug to it.
5. Connect the other plug wire to the - 5 volts of the power supply.
6. Insert an LED as shown in the pics. If it doesn't light, turn it around. You should use a known good LED for this first test.

Cheap and easy and quick.

Have fun

Idun El Cheapo Benhad

IMG 0156
IMG 0157
IMG 0158
IMG 0160

Share: