cheap controller fo...
 
Notifications
Clear all

cheap controller for bench testing lights

22 Posts
15 Users
0 Reactions
6,019 Views
Posts: 28
Topic starter
(@vipersinu2)
Eminent Member
Joined: 10 years ago

I am going to hold off until the f16v3 is available. then I will pull one of my F16v2's out of service for a bench tester! Thanks all


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

I think this has gotten a little off subject.....the average person isn't wanting to spend $200 for a test board. Even if it is a spare. Oops on your test bench, and there goes your $200 spare.

Assume we only need test board for testing pixels, and not run a show on the bench. Dumb RGB and single color strips can direct connected to a power supply, and 120v stuff can be plugged in.

What is a cheap controller for bench testing pixels: Renard Plus EPS WiFi Pixel controller kit @ $12. Typically is stock, and ships all year long....no group buy issues. It does 12 or 5V, and can do a lot of pixels. Plus you can learn Wifi at the same time.


Reply
Posts: 137
(@mikecentral)
Estimable Member
Joined: 10 years ago

+1 on the Renard Plus ESP WiFi Pixel controller kit

And if you buy 2 they are only $11 each :wink2:

They take about 10 minutes to assemble but you have to program the Arduino sketch. A fun little project. Buy a few and use them in your display. I have one INSIDE my arches. So I just need to run power. They connect wirelessly to your home WiFi


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

I didn't see anyone define cheap. I look it as the cheapest piece of test gear on my workbench. Next to a $350 multimeter and a $500 O-Scope, the $200 controller is for sure cheapest piece of electronic test equipment on my bench. I suppose it depends what you're testing. But I often find it very useful to address each pixel in a prop, assign grouping (group by 10, group by 2, helps to count how many are there, or how many till a problem pixel), determine appropriate brightness curves. Multiple outputs and internal patterns so I can burn-in a bunch of props at once. The little $20 controllers lack many or all of these functions or it's tedious to configure them. The full featured controllers give you everything you need, in an easy to use package at a price that's really nothing in the scope of what you're doing. It can certainly be the smaller version of the bigger controller, (6804 vs 682, or F4v2 vs f16v2) but the features really help for testing on the bench. The e6804 is probably the best bang for your buck at $70.
ESPs are nice, but the wifi introduces its own set of issues and I wouldn't consider it bulletproof enough to use for testing. not to mention it lacks a lot of the common internal features the others have.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago
Vipersinu2 wrote:is there a cheap controller that I can hook up to computer for bench testing lights from xlights.

Here is the original question......I don't think he is looking for test gear


Reply
Page 4 / 5
Share: