Cant log into E682!...
 
Notifications
Clear all

Cant log into E682!!

28 Posts
11 Users
0 Reactions
6,751 Views
Posts: 50
Topic starter
(@blarson)
Trusted Member
Joined: 11 years ago
JBRAVO wrote:unfortunately I'm having sort of the same problem.
1 i can't access the e682
2 i have everything plugged up and half of my pixel nodes are on, red and the next 18 pixels are green red blue white. and more brighter than the first 50 that are red.
can some one here help. first to access the e682 thanks guys

I was able to access my e682 by first using google chrome and second I pressed and held the button on the board down until the red and green led lights flashed 4 times which gave me a temporary IP address of 169.254.74.73 I then plugged that into google chrome and it popped right up. You might have to try the other temp IP's though. That's the one that worked for me.


Reply
Posts: 51
 bpos
(@bpos)
Trusted Member
Joined: 12 years ago

Have you by any chance changed computers or routers since you use this controller last? Perhaps try going to command prompt and typing "Ipconfig/all" and make sure your default gateway is not 192.168.0.X instead of 192.168.1.X?
If you reset the controller flashing 5 times will temp reset so you can try perhaps the other IP?

Just a thought?


Reply
JCook
Posts: 1003
(@jcook)
Noble Member
Joined: 13 years ago

You can use a scanner to scan your network to see if you can find the IPaddress or if it is even showing up on the network. go to http://angryip.org/ and download the AngryIp Scanner.

When you open the app, it will load the range of the subnet your PC is on.

Here is what my show network looks like. My PC is connected to my show network via WiFi and my home network via Lan cable.

ipscanner

Reply
RGB_Mixer
Posts: 270
(@rgb-mixer)
Reputable Member
Joined: 12 years ago
deonb wrote:Bit of a obvious thing here... but is your MAC/PC actually on the same subnet as your E682?

So if the E682 IP address is:
192.168.1.206

Is your desktop IP address:
192.168.1.x

?

Yes, I am with deonb on this one.

I have had a few strange things happen with both E682 and E6804 controllers in the past. I use Class "B" private IP settings and have some Class "C" IP settings for initializing some devices. Every time I have a problem, I check the network addresses for my machine. I use several different machines that are not setup the same. Caught that once.

Strangest problem I had was the controller lost its IP address. I had to do a manual reset to regain communications with the unit. I think it was a level 5 override? There I found the address did change ... how that happened was saving some settings and a glitch over-wrote the wrong area in the EEPROM.

If I am not mistaken, Jim St.John states the new v5 firmware allows for updates over the network along with a host of other goodies.

Good Luck!


Reply
Posts: 22
(@jbravo)
Eminent Member
Joined: 11 years ago

I did change computers I first was using mi Mac and then moved over to my pc to see if I could log in and I'm having the same problem. I don't know where to go to, to change the up address.


Reply
Page 4 / 6
Share: