Can't access E682 s...
 
Notifications
Clear all

Can't access E682 setup screen

15 Posts
7 Users
0 Reactions
4,932 Views
Posts: 121
Topic starter
(@jeremy-jackson28)
Estimable Member
Joined: 11 years ago

My computer does nothing when I plug in switch either. And I don't see the switch or controller In the control panel under devices. Seems like I should.

Sent from my iPhone using Tapatalk


Reply
Posts: 825
 DanJ
(@danj)
Prominent Member
Joined: 13 years ago

I know this won't really help all that much, but I have found that sometimes the E682 just doesn't pop up in explorer and you just have to keep trying. It'll come back up. Basic stuff--make sure your wiznet connector is well-seated into the little adapter to the PCB.


Reply
Posts: 327
(@thebaronn)
Reputable Member
Joined: 17 years ago
Jeremy.jackson28 wrote:It's connected straight to laptop. Only had it a week or so. Went to control panel under hardware. But I don't see it in there. Is there another place I should be looking

Sent from my iPhone using Tapatalk

Directly to the laptop, no router?

Every time I have ever connected the PC straight to the board I have had to do this:

ip config

Reply
Posts: 121
Topic starter
(@jeremy-jackson28)
Estimable Member
Joined: 11 years ago

I'll try it. But I've only hooked it straight to the PC. Never even used the switch yet.

Sent from my iPhone using Tapatalk


Reply
Posts: 1249
(@jstjohnz)
Noble Member
Joined: 17 years ago

Try using override 1 to verify that tne saved IP address is what you expect it to be.


Reply
Page 2 / 3
Share: