Calculating power s...
 
Notifications
Clear all

Calculating power supply load

3 Posts
2 Users
0 Reactions
1,148 Views
Posts: 92
Topic starter
(@curtinti)
Estimable Member
Joined: 7 years ago
[#53388]

When calculating power load on a power supply if a string of pixels is powered from a controller that is attach to one power supply and then power injected at the end of the string from a different power supply do i just assume 50% of that string is powered by one psu ad 50% is powered by the other?

Tim

Sent from my iPhone using Tapatalk


2 Replies
StickyWicket
Posts: 548
(@stickywicket)
Honorable Member
Joined: 14 years ago

First I highly suggest inspecting what you expect. Ie measure vs your calculations.

You don’t connect the positive wire when using multiple power supplies because of this you should know how many pixels exactly are on each power supply.


Reply
Posts: 92
Topic starter
(@curtinti)
Estimable Member
Joined: 7 years ago
StickyWicket wrote:First I highly suggest inspecting what you expect. Ie measure vs your calculations.

You don’t connect the positive wire when using multiple power supplies because of this you should know how many pixels exactly are on each power supply.

You’re right. Total brain fart newbie question. I have a power cut short extension or tee added to the string where i need to power from a different PSU.

Sent from my iPhone using Tapatalk


Reply
Share: